Wondering if quantum communication is just a faster internet? It isn’t. It encodes information in quantum states of photons, and its best-known use is sharing encryption keys whose security rests on physics rather than computational difficulty.
This page is part of the site’s coverage of quantum technology, where communication is one branch among several.
| Item | Value |
|---|---|
| Effective range of a point-to-point QKD system | About 100 km |
| Measured sifted key rate over 1 km of fiber | 4 Mbit/s |
| Measured sifted key rate over 4 km of fiber | 1 Mbit/s |
| Calculated sifted key rate over 8 km of fiber | 0.1 Mbit/s |
| Error rate at 1 km with the BB84 protocol | 3.6% |
The figures come from NIST’s QKD testbed page (updated April 2025) and its quantum information networks page (updated January 2022). They can change as research moves on, so check the sources before you rely on them.
What does quantum communication actually send?
According to NIST’s quantum information networks page, quantum communications deals with the exchange of information encoded in quantum states of matter, or quantum bits (qubits), between nearby and distant quantum systems. NIST’s project focuses on optical qubits, which are the quantum states of photons.
Detection is part of the challenge. The same page says single photons at telecommunication wavelengths can be detected with higher efficiency using NIST’s frequency up-conversion detector.
The page, as updated in January 2022, places this work inside quantum information science. It cites the National Science and Technology Council’s 2008 report, which names improved sensors, better medical imaging and a new computational paradigm as other possible payoffs. You can read about the measurement side in our guide to quantum sensing.
How a quantum link differs from an ordinary one
NIST’s fiber testbed shows the differences in practice. A quantum link is rarely a standalone replacement for an ordinary network. It runs next to one.
- Single-photon signals. In the testbed, the quantum channel carries 850 nm photons with a mean photon number of 0.1, according to the NIST testbed page.
- A classical channel alongside. A second channel transmits in both directions at 1510 and 1590 nm, per the same page. NIST says such classical channels send timing and framing information.
- Probabilistic detection. At the receiving end, arriving photons are randomly sent by a 50/50 coupler into different detection bases, as the NIST three-user network page describes.
- A different security basis. Security is based on the laws of physics rather than on mathematical or algorithmic computational complexity.
The practical lesson is that quantum and classical signals are engineered together. Timing, synchronization and control still depend on conventional channels.

Quantum key distribution: the best-known application
NIST describes quantum key distribution (QKD) as an approach that can provide unconditional security of communication, based on fundamental physics. The NIST three-user network page notes that QKD was first proposed in 1984. For the protocol details, see our explainer on quantum key distribution.
NIST’s system can run either the BB84 or the B92 protocol. B92 is relatively simple and cheap to implement and is widely used in laboratory studies. The same page says it is not as secure as BB84 and is vulnerable to the “intercept-resend” attack.
The key is only half the story. In NIST’s demonstration, video from a monitoring camera was encrypted with the secret key bits and sent over an unsecured public network, which in the experiment was just the Internet. The speed of the system enabled real-time one-time pad encryption and decryption of streaming video, per the same page.
So QKD supplies the key through a quantum channel, and the protected data itself can still travel over ordinary networks.
What do the numbers look like in practice?
NIST’s testbed page, updated April 2025, reports rates that fall quickly with distance:
- 4 Mbit/s of sifted key over 1 km of fiber.
- 1 Mbit/s of sifted key over 4 km of fiber.
- 0.1 Mbit/s over 8 km of fiber, a figure NIST gives from calculation rather than measurement.
After NIST upgraded the system to BB84 during its 2005-2006 work, it measured more than 4 Mb/s of sifted key with a 3.6% error rate over 1 km. Sifted key is an intermediate stage. An earlier B92 result on the same page was 2 Mb/s sifted key but 1 Mb/s of privacy-amplified secure key.
Networks add another layer. NIST’s three-node QKD network lets multiple users share a secure key, operating at 850 nm and 1550 nm with a 1.25 Gbps clock rate. A MEMS optical switch controls the route, and switching takes approximately 1 to 2 minutes.
A network manager sends commands over the internet for link switching, polarization recovery, key sifting, error reconciliation and privacy amplification. That lets the network reconfigure itself without manual tuning.
Why distance is the hard problem
NIST says the effective communication distance of a point-to-point QKD system is about 100 km, as of its page updated in January 2022. It calls quantum repeaters a promising solution, and says they are conceptually feasible but face tremendous development challenges.
A NIST-listed workshop page, updated September 2026, describes quantum networking as advancing from laboratory demonstrations toward early deployment. The workshop page lists entanglement distribution, quantum memory, quantum repeaters and QKD as enabling technologies. It was listed for September 17, 2026, at IEEE Quantum Week in Toronto.
The same page names the engineering challenges still to be addressed:
- Characterization and loss mitigation.
- Wavelength conversion for telecom compatibility.
- Synchronization.
- Error management.
It also points to standards work, with a long-term aim of informing future IEEE, IETF and ITU-T standards development.
Frequently asked questions
Is quantum communication the same as quantum computing?
Show answer
No. NIST’s quantum information networks page (updated January 2022) lists computation and sensing as separate possibilities within quantum information science. Quantum repeaters could eventually let distant quantum systems, including quantum computers, exchange quantum information.
Does QKD replace the internet?
Show answer
No. In NIST’s video demonstration, the key came from the quantum link, while the encrypted video traveled over the public Internet, as the NIST three-user network page explains.
How far can quantum communication reach?
Show answer
As of NIST’s January 2022 page update, the effective distance of a point-to-point QKD system is about 100 km. NIST points to quantum repeaters as a promising but difficult route to longer distances.
Is every QKD protocol equally secure?
Show answer
No. NIST’s three-user network page says B92 is not as secure as BB84 and is vulnerable to the “intercept-resend” attack, though it is simpler and cheaper to implement.



